FAQ's
Does my flue need to be swept or cleaned?
Yes. We recommend having your flue swept and inspected at least once every year.
Regular sweeping removes soot and creosote build-up from the flue system. Creosote is highly flammable and, if allowed to accumulate, can increase the risk of a chimney fire. Keeping your flue clean also helps your appliance operate more efficiently and maintain good draft.
Signs that your flue may need sweeping include:
- The fire is difficult to start.
- Smoke enters the room when lighting the fire.
- Sluggish fire performance or poor draft.
- A smoky or tar-like smell coming from the appliance or flue.
- Excessive soot deposits inside the firebox or flue.
- It has been more than 12 months since the flue was last cleaned.
If you are unsure whether your flue requires cleaning, a visual inspection by a qualified chimney sweep or installer can usually determine the level of soot and creosote build-up.
Tip: Burning dry, seasoned firewood will help minimise creosote build-up and reduce the frequency of cleaning required.
I can hear a whistling noise, is this normal?
Yes, in high winds or winds from a particular angle or direction can create whistling .
There can be many sources of whistling. The whistling can be hard to pinpoint.
Cowl
Some cowl designs are more susceptible to whistling than others. If the cowl is identified as the source, changing to a different style may help. Options include directional cowls or an ADD High Wind Cowl with a longer skirt. It can also be worthwhile looking at neighbouring properties in your area to see what type of cowl is commonly used.
Flashing cone, a longer sided flashing cone may help reduce the wind going across the top of the liner or down the liners.
Flashing Cone
Wind passing across the top of the outer liners can sometimes create noise. In some situations, a longer-sided flashing cone can help reduce turbulence around the liner and minimise whistling.
Secondary Air Tubes
On some wood fires, the secondary air tubes inside the firebox can create a whistling sound. A simple test is to slightly crack the fire door open. If the noise stops, the source may be related to the appliance's airflow rather than the flue system.
Do I need a flue shield?
The requirement for a single flue shield, double flue shield, or no flue shield is specific to the wood fire appliance being installed.
The required flue configuration is determined during the appliance's Appendix B clearance testing in accordance with AS/NZS 2918. These tests establish the minimum safe clearances to combustible materials and specify the flue system that must be used to achieve those clearances.
Because requirements vary between models, it is important to refer to the installation instructions for your particular appliance or contact the appliance manufacturer for guidance.
Installing the incorrect flue shield arrangement may result in the appliance not complying with its tested clearances or the requirements of AS/NZS 2918.
If you are unsure which flue shield configuration is required, please contact us with the make and model of your fire and we will be happy to assist.
What is the largest distance offset we can have?
If the offset is 30 through to 59 degrees from the vertical the maximum length is 1800mm
If the offset is more than 60 degrees from the vertical the maximum length is 900mm
It is important to note the maximum length is the length of the middle section of the offset, not the centre to centre distance.
If you have further questions, please contact us


